Mikro Track Le

> MikroTrack™

For creates a perfect three-dimensional impression

The first reusable footwear and tire track impression mold, MikroTrack™, creates a perfect three-dimensional impression with accurate recording of all pertinent information in the evidence.

The MikroTrack™ impression can be stored and will not dry. Once you’ve photographed and are done with the print, simply reshape it, and it’s ready to use again.

To make a three-dimensional impression of the shoe sole.

Roll out the MikroTrack™ dough on a clean surface with the rolling pin so that it corresponds to the surface of the shoe sole.

We recommend first brushing away loose dirt particles from the object as you are going to make a three-dimensional impression of. It is so that it does not get stuck in MikroTrack™.

Applying a thin layer of water on the shoe sole with water. Do it with a sponge or flower sprayer. It improves the impression quality and makes it easier to release the quality of the impression from the MikroTrack™ dough.

Press down the shoe sole in MikroTrack™ dough start with the heel as we show in the picture.

Roll over and push the middle of the shoe.

Continue to roll over and press the shoe down over the toe tip of the shoe.

Here is the result and the impression and it can be stored and that doesn’t dry. Once you’ve photographed and are done with the print, simply reshape it, and it’s ready to use again.

To make a three-dimensional impression of the wheel.

Rolling out the MikroTrack™ on cardboard paper or similar with a rolling pin so that it corresponds to the surface of the wheel.

We recommend first brushing away loose dirt particles from the wheel. It is so that it does not get stuck in MikroTrack™.

Place the carton with the dough MikroTrack™ on the ground next to the wheel. Place a second cardboard disc so that the wheel can easily roll onto the disc.

Applying a thin layer of water on the wheel sole with water. Do it with a sponge or flower sprayer. This improves the quality of the impression and makes it easier to release the MikroTrack™ dough.

Roll the wheel over the MikroTrack™ dough as we show in the picture.

Here is the result and the impression and it can be stored and that doesn’t dry. To examining the three-dimensional impression we use a handheld Versa Light MAX.

Once you’ve photographed and are done with the print, simply reshape it, and it’s ready to use again.