> MikroTrack™

For creates a perfect three-dimensional impression

The first reusable footwear and tire track impression mould MikroTrack™ creates a perfect three-dimensional impression with accurate recording of all pertinent information in the evidence. The MikroTrack™ impression can be stored and will not dry. Once photographed impression, just mould it back together and it’s ready to use again.

> Creates a perfect shoe impression

To make a three-dimensional impression of the shoe sole. Roll out the MikroTrack™ dough on a clean surface with the rolling pin so that it corresponds to the surface of the shoe sole.

We recommend first applying a thin layer of water on the shoe sole with water. Do it with a sponge or flower sprayer this improves the impression quality and makes it easier to release from the MikroTrack™ dough.

Press down the shoe sole in MikroTrack™  dough start with the heel as we show in the picture.

Roll over and push Middle of the shoe

Continue roll over and press the shoe down over the toe tip of the shoe

Here is the result and impression can be stored and will not dry.
Once photographed impression, just mould it back together and it’s ready to use again.

> Creates a perfect wheel impression

To make a three-dimensional impression of the Wheel. Rolling out the MikroTrack™ at cardboard paper or similar with the rolling pin so that it corresponds to the surface of the Wheel.

Lie down and place the MikroTrack dough on the ground. Place a cardboard disc so that the wheel rolls up easily.

We recommend first applying a thin layer of water on the wheel sole with water. Do it with a sponge or flower sprayer this improves the impression quality and makes it easier to release from the MikroTrack™ dough.

Roll over wheel over the Microtrack dough as we show in the picture.

To examining the three-dimensional impression we use a handheld Versa Light MAX.

> Back to learning